+86-18822802390

EMI Projektowanie Oparte Na A Przełączanie Zasilanie Zasilanie Urządzenie

Aug 22, 2023

EMI Projektowanie Oparte Na A Przełączanie Zasilanie Zasilanie Urządzenie

 

Usually, the processing process of simulation software for engineering problems such as EMC/EMI is "modeling>reproducing problems>ulepszanie projektowanie". Jednak , EMC/EMI problem ma charakterystyka przypadkowość i zmienność, tworzenie to trudne to w pełni replikacja an faktyczna inżynieria EMC/EMI problem. Ansoft's "top-down" EMC solution can easy solve this problem. Jeśli ty jesteś zmagasz się z EMC/EMI powiązane problemy w motoryzacja elektronika projektowanie, przełączanie zasilanie projektowanie, system projektowanie, lub urządzenie projektowanie, to seria artykułów będzie analiza inżynieria przykłady do pomoc ty rozwiążesz te problemy.


Rockwell zastosowane Ansoft projekt proces dla EMI projekt z jeden z jego przełączanie zasilanie zasilanie urządzenia:


1. Use Q3D to extract parasitic parameters from the PCB layout of the switching power supply.


2. Build a virtual testing platform for conducting interference simulation in Simplorer. The physical part of Figure 10 shows the circuit used for actual measurement of conducted emissions from a switching power supply, including a DC power supply, a linear imped stable network (LISN), and the tested switching power supply board. The following is the schematic diagram of a virtual testing platform built in Simplorer, with the blue part using the layout parasitic parameter model extracted from Q3D.


3. Dziedzina czasu przebiegi z wspólne mod i różnicowe tryb interferencja napięcia wyjście przez the LISN sieć uzyskane przez Simplorer simulation, and the frequency spectrum of common mode and differential mode EMI in the range of 150KHz~30MHz uzyskane through FFT transformation, are the comparison between the simulation results and the measured results. The black line represents the simulation results and the red line represents the measured results, which have good consistency.


4. With the help of the Simplorer simulation platform, designers can conduct thorough "what if" research on the performance of device prototypes before processing and testing them, and fast validate ich design ideas on the virtual testing platform provided by the software. Figure 12 shows the conducted EMI simulation results after improving the initial design. The black line represents the initial simulation results, the yellow line represents the simulation results with EMI filtering, the red line represents the conducted EMI simulation results with EMI filtering and XFMR shielding, and the green and blue lines represent the requirements for conducted EMI in the CISPRA and CISPRB standards, odpowiednio.

 

Switch power supply

Wyślij zapytanie