Diagnostyka metoda dla usterka z falownik moc przełącznik rura
Zmienna częstotliwość prędkość sterowanie system jest skomponowany z dwa części: a częstotliwość konwerter i an elektryczny silnik. Jednak, prawdopodobieństw z usterek występujący w częstotliwość konwerter część jest wyższy, i an ważny czynnik wiodący do wysoki awaryjny stopa z częstotliwości konwerter jest częste występowanie przełącznik lampa usterki. Są cztery główne metody dla usterka diagnoza z przełącznik lampy: ekspert system metoda, napięcie detekcja metoda, inteligentna algorytm, i prąd detekcja metoda.
(1) Ekspert system metoda odnosi się do listing of possible faults based on experience in fault and combined with specific situations, continuous enriching and summarizing them, and final forming a systematic knowledge base. So when the fault occurs again, diagnosis can be made by byfuling this knowledge base, but the fault of this diagnostic method is that it can establish the knowledge base complete and zupełnie.
(2) Napięcie detekcja metoda jest używane do diagnozowanie usterki przez badanie odchylenie między faza napięcie, linia napięcie, lub neutralne punkt napięcie z silnika podczas a częstotliwość konwerter usterka i normalne warunki.
(3) Intelligent algorithms refer to general optimization algorithms. In variable frequency speed control systems, intelligent algorithms mainly include artificial neural networks, wavelet analysis, and fuzzy control.
(4) Current detection method is mainly used to normalize the current by grasping the current value, in order to control the switch tube well.
After a switch tube failure, there are two methods for recovery: one is to use redundant control; Another type is fault-tolerant control. Redundant control is used in systems with high reliability. It is to use redundant switches during operation when there is a failure in the switch tube. Fault tolerant control is the connection between each phase bridge arm and the motor through a relay. W trakcie normalny operacja, przekaźnik dla neutralny faza z silnik jest odłączony i ten faza jest nie aktywowany. Kiedy a przełącznik rura z a pewna sekcja awarie podczas operacja, przekaźnik z tamta faza otwiera, która może minimalizować straty spowodowane przez nagłe awarie.
